Philips HX6733-90 - Manual (Page 7)

1 Press the on/off button to toggle between
modes.
The green LED indicates the selected mode.
Note: You can only switch between modes when the
toothbrush is turned on.
Clean mode
Standard mode for superior teeth cleaning.
Sensitive mode (select models)
Gentle, yet thorough cleaning for sensitive gums and
teeth.
Clean and White mode
2 minutes of Clean mode, with an additional
30 seconds of White mode to focus on your
visible front teeth.
Note: When Sonicare is used in clinical studies, the
default 2-minute Clean mode must be selected.
However, in whitening/stain reduction studies, the Clean
and White mode must be selected. The handle should
be fully charged and the Easy-start feature deactivated.
Features
Easy-start
This Sonicare model comes with the Easy-start
feature activated.
The Easy-start feature gently increases power over
the first 14 brushings to ease into the Sonicare
experience.
Note: Each of the first 14 brushings must be at least 1
minute in length to move through the Easy-start ramp-
up cycle properly.
,
-
-
EngliSH 1
Note: When the Clean and White mode is selected, the
Easy-start feature is inactive.
Deactivating or activating the Easy-start
feature
1 Attach your brush head to the handle.
 Place the handle in the plugged-in charger.
To deactivate Easy-start:
Press and hold the power on/off button for 2
seconds. You hear 1 beep to indicate that the Easy-
start feature has been deactivated.
To activate Easy-start:
Press and hold the power on/off button for 2
seconds. You hear 2 beeps to indicate that the Easy-
start feature has been activated.
Note: Using the Easy-start feature beyond the initial
ramp-up period is not recommended and reduces
Sonicare’s effectiveness in removing plaque.
Smartimer
The Smartimer indicates that your brushing cycle is
complete by automatically turning off the toothbrush
at the end of the brushing cycle.
Dental professionals recommend brushing no less
than 2 minutes twice a day.
If you want to pause or stop brushing during your
2-minute cycle, press and hold the power on/off
button for 2 seconds. Press the power on/off button
again and the Smartimer picks up where you left off.
The Smartimer automatically resets to the beginning
of a 2-minute cycle if:
brushing is paused for 30 seconds or longer.
the handle is returned to the charger.
-
-
-
-
EngliSH 1