Philips AJ7030DG-37 - Manual (Page 10)

10 EN
3 Get started
Always follow the instructions in this chapter in
sequence.
Install battery
Caution
•
Risk of explosion! Keep batteries away from heat,
sunshine or fire. Never discard batteries in fire.
• Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type.
• The battery contains chemical substances, so it should
be disposed of properly.
• Perchlorate Material - special handling may apply. See
www.dtsc.ca.gov/hazardouswaste/perchlorate.
Note
•
You can only use AC power as power supply. The pre-
installed lithium CR2032 battery can only back up time
and alarm.
For first-time use:
Remove the protective tab to activate the
battery.
To replace the battery:
Connect power
Caution
• Risk of product damage! Ensure that the power voltage
corresponds to the voltage printed on the back or
underside of the clock radio.
• Risk of electric shock! When you unplug the AC
adapter, always pull the plug from the socket. Never
pull the cord.
Set clock
1
In standby mode, press and hold SET
for two seconds to activate clock setting
mode.
» [12H] or [24H] is displayed.
2
Press TUNING +/- or / repeatedly to
select 12/24 hour format.
3
Press SET again to confirm.
» The hour digits begin to blink.
4
Repeat Steps 2 to 3 to set the hour and
minute.
Note
• If clock is not manually set, when iPhone/iPod is
connected, the clock radio synchronizes time from the
iPhone/iPod automatically.