Philips 26PF9966-37 - Manual (Page 29)

29
R
1
2
Press the SELECT button repeatedly until
TV mode is selected.
While in TV mode, press the SELECT
and the POWER button simultaneously.
The ACC LED will blink once.
Enter a digit to select the device.
Enter digit 2 for Cable/SAT,
digit 3 for VCR
digit 4 for DVD
The ACC LED will blink once if the
correct digit is pressed for the selected
device.
Enter a four-digit code from the
Remote Control Direct Entry Codes list.
(See pages 30 - 32).
Press the TV/DVD/AUX/ACC SELECT
button repeatedly to select the ACC mode.
Your remote control can now be used with
your accessory device.
3
H ELPFUL H INT
1
3
2
4
IMPORTANT
• When programming the universal code, TV mode
must be selected.
• If more than four digits are entered, the remote
control will only retain the first four digits.
• If the wrong four-digit code is keyed in, you have
to repeat Steps 1 - 4 again.
• After keying a digit, you are only allowed a thirty
seconds time limit to key your next digit. If you
exceed the time limit, you have to repeat Steps
1 - 4 again.
4
2
Y ou can also set up the remote control for use with other
accessory device brands.
Follow the steps 1 - 4 to program the universal code.
H
OW TO
P
ROGRAM THE
U
NIVERSAL
C
ODE WITH OTHER
A
CCESSORY
D
EVICES
5
5