Bose Wave Radio - Manual (Page 20)

20
Operating Your Wave ® Radio/CD
Setting the alarms
Note: You can set alarms with the Wave Radio/CD on or off.
Function
To enter alarm setup mode - Press and release Alarm Setup. The system is now in alarm
setup mode. ALARM 1 flashes for 10 seconds.
To select which alarm to set - While ALARM 1 is flashing, set alarm time, volume, and alarm
sound (tone , radio, or CD), for Alarm 1. Press Alarm Setup again until ALARM 2 is flashing.
While it flashes for 10 seconds, begin to set Alarm 2.
To set the alarm time - While the selected alarm is flashing, press the Time or to set the
alarm time. The selected alarm flashes for 10 seconds.
To set the alarm source - While the selected alarm is flashing, press FM, AM, or CD to select
and display that source. The tone is no longer selected.
• To reset to tone, press the source currently selected (FM, AM, or CD), which deselects it.
• When no source is displayed, the alarm is set to tone .
• Setting FM or AM alarm, the station last used for this alarm is shown. Or, use Presets or
Track⁄Tune
or to select a station.
• Setting CD alarm, track 1 is shown. Or, use Track⁄Tune or to select a specific track or time
location for the alarm. Press CD Mode to select RANDOM or TRACK REPEAT. The CD
plays, repeating as needed, until the alarm shuts off.
• To set radio or CD followed by tone , select radio or CD alarm, then press CD Stop
■.
AUX is not available as an alarm source.
To set the alarm volume - While the selected alarm is flashing, press Volume
▲ or ▼ to set
the alarm volume, from 10 to 99. The selected alarm flashes for 10 seconds.
To test the alarm volume - While the selected alarm is flashing, hold down Alarm Setup and
press Volume
▲ or ▼ to hear the volume setting, as demonstrated by the tone alarm only.
To adjust snooze time - The system is set for a standard 10-minute snooze time (the number
of minutes you can delay the alarm). While the selected alarm is flashing, hold down Sleep⁄Snooze
and press the Time
or to adjust the snooze time (from 1 to 30 minutes) for that alarm. The
number of minutes and Sn appear on the display to confirm your selected snooze time. You can
set a different snooze time for each alarm.
To exit from alarm setup - To leave alarm setup mode, wait 10 seconds for it to disengage.
Or you can press AUX once or Alarm Setup a few times until there is no ALARM 1 or ALARM 2
flashing.
To check the alarm setting - To display the alarm setting for 10 seconds, press and release
Alarm Setup. Press again to display one alarm setup and repeat to display the other alarm setup.
Alarm
Setup
FM AM
Track/Tune
AUX
Reading the alarm setup displays
Figure 13
Examples of alarm setup
displays
Time Time
Alarm
Setup
Alarm
Setup
Alarm
Setup
Sleep/Snooze
Time Time
CD Play
CD Stop
ALARM 1 flashes. You can begin by setting the time.
Pressing FM selects it as the source for ALARM 1.
ALARM 2 flashes. You can begin by setting the time.
Pressing CD selects it as the source for ALARM 2.
1
2
Alarm
Setup
4
Alarm
Setup
3
CD Play FM
Presets
Volume
AUX
On/Off
Alarm
Setup
4 5 6
Track/Tune
Sleep/Snooze
Wave Radio/CD
Alarm 1
On/Off Alarm 2
On/Off
1 2 3
FM AM Stop
Alarm
CD Play CD Mode CD Stop
Time Time
Control panel
CD Mode
Alarm
Setup