Philips 60PP970199 - Manual (Page 8)

P
ICTURE
M
ENU
C
ONTROLS
(
CONTINUED
)
2 1 3
5 4 6
8 7 9
0
TV VCR ACC
GUIDE
AV
INFO
SWAP PIP CH
UP
SOURCE FREEZE
FORMAT AUTO
STATUS/
EXIT
VOL CH
MUTE
SURF 100+
POWER
MENU/
SELECT
4
1
3
1
MAIN MENU
PICTURE
FEATURES
SOUND
EXIT
PICTURE MENU
FLESH CORRECTION
EXIT
2 OF 3
MORE...
CONVERGENCE
PICTURE MENU
SHARP
PICTURE
CLEARVIEW
EXIT
1 OF 3
COLOR TINT
MORE...
BRIGHT
1ST TIME SETUP
2
POSITION
DN
PIP
VIDEO ENHANCEMENT
PRESS TO ALIGN RED
PRESS MENU TO RETURN
CONVERGENCE MENU
ALIGN RED
ALIGN BLUE
CONVERGE MULTI POINT
BACK
RED/BLUE CONVERGENCE
C onvergence is the correct
lining up of the red and blue
light paths on the TV screen.
NOTE: If no color fringing (see
Smart Help) shows, then no
Convergence adjustments are
necessary for your TV.
Select CONVERGENCE
control.
With PICTURE MENU (2 of 3) on
screen, move the RED highlight
with the outer MENU ring
buttons. Then press the center
MENU button to select the feature.
If there is RED or BLUE color
fringing (see note below) on your
TV, press the outer MENU ring
buttons to move the highlight.
Press the center MENU button to
select the Align Red or Align Blue
Convergence control.
Press the MENU ring
buttons to move the red or blue
cross directly over the white cross
on the TV screen.
The red or blue cross is properly
adjusted when it is completely
merged with the white cross. (No
color appears around the edge of
the white cross).
Press the STATUS button to
clear the screen when convergence
adjustments are complete.
1
2
3
STOP
S MART H ELP
Remember. Convergence
has been set at the factory for
best viewing, but if one or more of
the (red or blue) colors appear
around the edges of objects (color
fringing) follow the steps given in
this section.
BEGIN
4
8
NOTE: Adjustments for
“Multi-Point” on-screen color
fringing can also be made as
part of the TV’s Convergence
control system. Follow the TV’s
on-screen menu directions to
select individual screen areas that can
be readjusted and set for varying
red/blue color fringing conditions.
These multi-point settings can then be
“Saved” to memory for the specific areas of the TV
screen (or Factory Settings for convergence can be
recalled and put back into place for use).
CONVERGENCE MULTI POINT
CONVERGE RED POINTS
CONVERGE BLUE POINTS
RESTORE FACTORY SETTINGS
SAVE ADJUSTMENTS
BACK
CONVERGE RED POINTS
USE TO ADJUST
DIGIT 2, 4, 6, 8 TO MOVE CURSOR
PRESS MENU TO RETURN
PRESS MENU NOW TO CONTINUE
MULTI-POINT
CONVERGENCE