Philips 30PW850H - Manual (Page 48)

48
F ollow these simple steps to have your TV
remote search for the code it needs to work
the functions of your accessory device. Please
read through the steps once before performing
them.
NOTE: The Search method works only with
devices equipped with channel display indica-
tors or channel display capability.
1 Press the POWER button on the
device your are attempting to program
to turn it ON.
2 Slide the TV/VCR/ACC mode switch
to the VCR position if you’re setting
up a VCR or to the ACC position if
you’re setting up any other accessory
device.
3 Press the REC(ord)/SAP and
SOUND buttons simultaneously and
hold them down. The device will begin
to change channels after the remote
identifies the correct code.
4 When the channels start to change,
release the REC(ord)/SAP and
SOUND buttons.
NOTE: Don’t let the device scan up more
than five channels. If you do, the remote con-
trol may pass up the correct code, and another
two-minute search cycle will have to be done.
If no channel change happens within two
minutes, repeat steps 1–4. Should a channel
change still not occur, the remote will not
work the desired device.
U
SING THE
R
EMOTE WITH
A
CCESSORY
D
EVICES
- S
EARCH
06
07
08
09
06
07
08
09
07
08
09
2
4
1
3
4
Cable Converter
Satellite Receiver
VCR
Don’t let the device scan up more than five
channels. If you do, the remote may pass up
the right code, and another two-minute
search cycle will have to be done.
If no channel change happens within two
minutes, repeat steps 1–4. Should a channel
change still not occur, the remote control
will not work the desired device.
It is recommended that you use Philips
brand external accessory devices with your
Philips television to insure proper remote
control functions. If you are using Philips
brand accessory devices, your remote con-
trol should be ready to use with these
devices.
H
ELPFUL
H
INT