Philips 19PS30C - Manual (Page 5)

75 ⍀
IN
OUT
75
⍀
2
1
Y our Cable TV input into your
home may be a single (75 ohm)
cable, or a Converter Box installa-
tion. In either case the connection to
the TV is very easy. Just put the
threaded end of the cable signal to
the TV's antenna plug and screw it
down tight.
If your Cable TV signal is a single
round cable (75 ohm) then you're
ready to connect to the TV.
If you have a Cable Converter Box:
Connect the Cable TV signal to the
Cable Signal IN(put) plug on the
Converter.
Connect the Cable TV cable to the
75
Ω
plug on the TV.
If you have a Cable Converter Box:
Connect the OUT(put) plug from the
Converter to the 75
Ω
plug on the TV.
Remember: Set the TV for the
type signal you've just connected
(see the “Tuner Mode” section on page
11 of this manual.)
To select only the channel numbers on
your Cable system see “Auto Program"
(page 12). If you use a Cable Converter
box, set the TV to the same channel as
the converter's CH 3/4 switch (on the rear
of the converter.)
S MART H ELP
5
H
OOKING
U
P
Y
OUR
TV (B
ASIC
C
ABLE
TV C
ONNECTIONS
)
Cable TV Company
Cable TV Signal Input
Cable TV Converter
Box Connection
Round Cable
75
Ω
Ohm
OR
Back of TV