Philips AZ1015-17 - Manual (Page 14)

GENERAL INFORMATION
14
English
Do not expose the set, batteries, CDs, or tapes to humidity,
rain, sand, or excessive heat (caused by heating equipment or
direct sunlight).
The mechanical parts of the set contain self-lubricating bearings
and must not be oiled or lubricated!
You can clean the set with a soft, slightly dampened, lint-free cloth.
Do not use any cleaning agents as they may have a corrosive effect.
To ensure proper recording and playback quality, clean parts
A, B and C after approximately 50 hours of operation. Use a
cotton swab slightly moistened with alcohol or head-cleaner fluid.
Press PLAY 1 and clean the rubber pressure roller A.
Press PAUSE ; and clean the capstan B and the heads C.
Note: Cleaning of the heads C can also be done by playing a
cleaning tape once.
The lens X of the CD player should never be touched. Always
keep the CD compartment closed to avoid dust on the lens.
The lens may cloud over when the set is suddenly moved from cold
to warm surroundings. Playing a CD is not possible then. Leave the
CD player in a warm environment until the moisture evaporates.
To take the CD out of its box easily, press the center spindle while
lifting the CD. Always pick up the CD by the edge and put it back
in its box after use.
To clean the CD, wipe it in a straight line from the center toward
the edge using a soft, lint-free cloth. A cleaning agent may
damage the disc!
Never write on a CD or attach a sticker to it.
STOP OPEN
SEARCH
PLAY
RECORD
HSPEED DUBBING
X
CD player and CD handling
CD RADIO CASSETTE RECORDER
A
B
C
C
Tape deck maintenance
General maintenance
CAUTION
Use of controls or adjustments or performance of procedures other than here-
in may result in hazardous radiation exposure.
AZ1015/17.1a eng usa 8/17/00 5:02 PM Page 14