Philips 8170XLCC-40 - Manual (Page 14)

ENGLISH 27 ENGLISH 26
C
7 If the shaving unit becomes detached from
the razor, you can easily reattach it.
8 You may also clean the hair chamber
without water by using the supplied brush.
After Each Use: Trimmer
1 Turn razor OFF.
2 Push down spring-release trimmer switch.
C
3 Clean trimmer with the brush every time
you use it.
C
4 Lubricate the trimmer teeth with Philips
Norelco Razor Lubricant (model AL80) or
with one drop of mineral oil every 6 months.
5 Close trimmer by pressing trimmer down.
This razor and Jet Clean System have no other user-
serviceable parts. Any other service should be
performed by the Philips Norelco Service Location.
Cleaning the Jet Clean Canister
For optimal performance of the Jet Clean System,it
is recommended that you empty the cleaning
solution canister and thoroughly rinse the canister
clean every 2 weeks.
1 Place the Jet Clean System on a flat, level
surface.
1 Always turn razor OFF, unplug from outlet
and remove cord from razor before
cleaning.
C
2 Press the Razor Head Release Button, flip
open the Razor Head Assembly.
C
3 Clean inside razor heads and hair chamber
by running under hot water.
C
4 Clean outside of Razor Head Assembly by
running under hot water.
5 Close the Razor Head Assembly and shake
off excess water.
C
6 Open Razor Head assembly again and
leave open to air dry.
NOTE: Do not wipe or dry the shaving heads
with a towel or tissue.This could damage the
shaving heads.