Philips AT928-41 - Manual (Page 11)

ENGLISH
w If the shaving unit becomes detached from the
razor, you can easily reattach it.
w You may also clean the hair chamber without
water by using the supplied brush.
Extra-thorough Cleaning Method
Do not mix up the cutters and combs as the
shaving performance may be adversely affected
for several weeks before optimal shaving
performance is restored.
1 Turn razor OFF, remove the charging plug
from the outlet and power cord from the
razor.
C
2 Press the Razor Head Release Button to
open the Razor Head Assembly.
C
3 Pull the shaving unit off the razor.
C
4 Turn the lock counterclockwise to unlock
(A) and remove the retaining frame (B).
20
ENGLISH
C
5 Remove and clean one set of cutters and
combs at a time.
C
6 Separate the cutter from the comb and
clean it with the short bristled side of the
brush supplied.
Do not clean more than one cutter and comb
at a time, since they are all matching sets. If you
accidentally interchange the cutters and combs, it
could take several weeks before optimal shaving
performance is restored.
C
7 Clean the inside and outside of the comb
with the brush supplied.
For optimum performance, razor cutters and
combs should be cleaned in a degreasing liquid
(e.g. Philips Norelco Shaving Head Cleaning Spray,
Model HQ110 or alcohol) and lubricated with
one drop of mineral oil (in the center of the
head). This helps prevent wear of the shaving
heads.
C
8 Replace the set back into the Razor Head
Assembly.
Make sure that the two pointy edges of the head
fit exactly into the recesses.
21
A
B