InnoMax Adjustable Bed Base - Manual (Page 12)

PowerBASE™ Owners Manual 99300787-i
12
failure TO fOllOw HeadBOard
BraCkeT insTallaTiOn insTruCTiOns
May Cause HeadBOard BraCkeT
inTerferenCe wiTH Base fOaM durinG
adjusTaBle Bed OperaTiOn. Base fOaM
Or Base COver daMaGe COuld resulT.
NOTE
3 inches M
aX
.
fiGure 15: Headboard cross member location must not
exceed 3 inches (76.2mm) from the top of the mattress. 11. Install headboard brackets to the bed
base frame*. When attaching (2) twin
size units to a king size headboard an
optional swing hinge kit (see accessory
section) may be used to connect the twin
units.
Note: It is important to position the
bottom of the headboard cross member
a maximum distance of 3 inches
(76.2mm) between the headboard and
the top of the mattress (FIGurE 15). Do
not exceed 3 inches (76.2mm).
* S-cape™ and optima are Type A bed
base frames. Silhouette™, Profile, and
Pro-Motion™ are Type B bed base
frames.
Note: if adjustable bed is to be set up
without a headboard, basic installation
is now complete. If headboard is to be
installed, proceed to Headboard Bracket
Installation.
fiGure 14: Mattress retainer installed.