Brinkmann 7741 Series - Manual (Page 26)

Step 3
Set upper grill body assembly
on the grill base and secure the
sides with four M6 X 12mm bolts.
Afterwards, secure the back of the
grill body assembly with three
M6 X 12mm bolts, three M6 washers
three M6 lock washers and three M6
nuts.
Step 4
Remove rotisserie burner cover
from rotisserie burner assembly.
The bolts and washers removed
will be used again in Step 6.
Step 5
Attach gas supply line to pre-installed
rotisserie burner orifice using two
M4 X 8mm bolts as illustrated.
Step 6
Replace rotisserie burner cover over
rotisserie burner assembly and
secure. Make sure rotisserie ground
wire is inserted under one of the
rotisserie burner cover bolts for a
proper ground.
Step 7
Attach the rotisserie burner electrode
wire to the igniter module located
inside the right door. The connection
should be made to the only open
terminal.
Step 8
Place hood on the grill and align with
holes, then secure hood with hood
bolts and cotter pins as shown.
25
Electrode Wire
Igniter
Module
Upper Grill Body
Assembly
Hood
Cotter Pin
Head Bolt
Battery Compartment
Location of
Rotisserie
Burner Igniter
Burner
Orifice
Gas Supply
Line
Rotisserie
Burner Cover
Ground
Wire
M4 X 8mm
Bolts