Hale Master Intake Valve - Manual (Page 18)

16
M
ASTER
I
NTAKE
V
ALVE
head screws. Do not remove gearmotor
-the drive pin could drop out. Rotate
gearmotor so circuit breaker is located
toward top. Apply Loctite #242 or equal
to threads of #6-32 socket head screws
reinstall and tighten.
9. Be sure wiring connections are properly
and firmly attached. Slide strain relief in
cover cutout and slide cover over
gearmotor and adapter lining up holes.
Apply Loctite #242 or equal to threads of
#6-32 screws reinstall and tighten.
10. If valve is equipped with an electric
gearmotor and the gearmotor is
mounted vertically, the gearmotor
cover must have a drain hole added in
the bottom. Remove the four #6-32 x 1/2
inch long screws and remove the cover.
Drill a 5/16 hole through end of cover
and deburr. Slide strain relief in cover
cutout and slide cover over gearmotor
and adapter lining up holes. Apply
Loctite #242 or equal to threads of #6-32
screws reinstall and tighten.