Hale Fyr Port - Manual (Page 16)

SAFETY PRECAUTIONS:
1. DO NOT RUN THE ENGINE IN AN ENCLOSED AREA. Be sure the area is well
ventilated.
2. Stay away from moving parts. Avoid wearing loose jackets, shirts and ties.
3. Keep the equipment and surrounding area clean. Cluttered areas invite accidents.
4. Keep power shields and guards in place. Do not make adjustments and repairs while
the engine is running, unless specified for in repairs.
5. Do not run the pump more than two min. without water in pump.
6. Be careful not to touch the exterior of a hot engine, especially the muffler and the
surrounding area.
7. Prevent accidental starting by always removing spark plug or by disconnecting and
grounding spark plug wire before working on engine or pump.
8. When working on any part of the fuel system be sure the unit is cool. Remove any
sources of heat or flame.
ABSOLUTELY NO SMOKING
Reassembly Note:
Before reassembly begins, visually inspect parts. See that parts are clean; all
sealing surfaces are free of corrosion and nicks. Remove any metal chips from casting
cavities and tapped holes. Also inspect for any damaged or excessively worn parts
which should be replaced.
Refer to ‘’Parts Catalog’’ Plate NO. 534B, 1 of 2 of 2, for component parts’
location and orientation.
MAINTENANCE SCHEDULE;
Daily or Every 8 hours:
1. Leaks - (gaskets, fuel, seals, washers, and water) Check for any leaks before
operating unit. These leaks must be repaired before operating.
2. Pump Inlet:
a) Remove any debris that might collect in the inlet, impeller eye, or the inlet hose
strainer.