Document Outline

• Skid and Trailer Manual, p/n: 029-0810-00-0
  • NOTICE !
  • Contents
  • Hale Skid and Trailer Systems
    • Figure A: Model Number Breakdown
    • Figure B: Serial and Model Numbers
    • Figure C: Typical - Enclosed Skid Arrangement
    • Figure D: Typical - Cross-Chassis Non-Enclosed Skid Arrangement
    • Figure E: Typical Tandem Trailer Arrangement
    • Figure F: Typical - Skid / Trailer Control Panel Arrangement
    • Figure G: Optional - Typical Skid / Trailer Electronic Governor Control Panel
  • 1 Safety Precautions
    • 1.1 Definitions
    • 1.2 General
    • 1.3 Skid Assembly
    • 1.4 Trailer Assembly
  • 2 Introduction
    • 2.1 System Components
      • Hale Pump
      • Engine
      • Gearbox
      • Skid
      • Trailer
      • Operator Control Panel, Typical
        • Pressure Gauges, Vacuum and Master Discharge
        • Control Display Light
        • Relief Valve
        • ENFO IV Engine Monitor
        • Engine Warning Light
        • Hour Meter
        • Fuel Gauge
        • Engine Throttle
        • Primer Valve Control
        • Engine OFF / RUN / START Switch
        • Engine Shut-Down Override Push Button
  • 2a Accessories / Options
    • 2a.1 Anodes
      • Figure 2a-1: Hale 1-1/4” NPT Anode
    • 2a.2 Auto-Start
    • 2a.3 Auxiliary Cooling
      • Gearbox Manifold Coolers
        • Figure 2a-2: Typical Gearbox Manifold Coolers
      • Heat Exchanger, “K” Series
        • Figure 2a-3: Model “K” Heat Exchanger
    • 2a.4 Engine Governor Control, Optional
      • Figure 2a-4: Optional - Engine Governor Control
    • 2a.5 Foam Proportioning System
      • Figure 2a-5: Typical Foam Proportioning System
    • 2a.6 Pressure and Relief Valve Control
      • Figure 2a-6: P Series Relief Valve Control
      • P Series Relief Valve System
      • Thermal Relief Valves (TRV)
        • Figure 2a-7: Thermal Relief Valve, TRV
        • TRV-L Kit
    • 2a.7 Priming Systems
      • Figure 2a-8: Rotary Vane ESP Priming Pump
      • Priming Valves
        • Figure 2a-9: SPVR Priming Valves
        • Figure 2a-10: PVG Priming Valves
    • 2a.8 Torrent SVS Valves
      • Figure 2a-11: SVS Valve Primary Components
  • 3 Basic Operation
    • 3.1 Overview
    • 3.2 Fluid Levels
    • 3.3 Preparing to Tow
      • Pre-tow inspection
      • Regular STOPS inspection
    • 3.4 Pumping Operations
      • Initial Start Up
      • Pumping Operations
      • Draft Operation Limiting Factors
    • 3.5 Relief Valve Procedures
      • Standard Relief Valve Procedures
      • TPM Relief Valve Procedures
        • Figure 3-1: TPM / PMD Relief Valve Control
    • 3.6 Post Operation Procedures
  • 4 Preventive Maintenance
    • 4.1 Overview
      • For Preventive / General Maintenance
        • Engine
        • Trailer
        • Pump
        • Gearbox
        • Accessories
    • 4.2 Post Operation
      • Fluids
      • General Review
        • Brakes
        • Electrical
        • Tires / Wheels
        • Trailer
        • During Operation
        • Torque Requirements
    • 4.3 Storage
      • Hale Pump and Gearbox Assemblies
  • 5 Troubleshooting
    • 5.1 Overview
      • For Troubleshooting
        • Engine
        • Trailer
        • Pump
        • Gearbox
        • Accessories
  • 6 Installation
    • 6.1 Overview
    • 6.2 Frame Mounting
      • General Mounting Suggestions
        • Figure 6-1: Recommended Permanent Installation
    • 6.3 Plumbing, Skid and Trailer
      • System Preparation
        • General
        • Skids
        • Trailers
  • Appendix A: Glossary
  • Appendix A-1: Measurements
    • Conversion Chart
  • Appendix C: Alternate Lubricant Manufacturers
    • Table C-1: Alternate Lubricant Manufacturers
  • Appendix C1: Lube and Sealant Specifications
    • Table C1-2: Oil Capacity and Recommendation
    • Grease
    • Loctite Sealant
    • Oil
    • Recommended Cleaners
  • Appendix D: Hose Friction Loss
    • Table D-1: Hose Friction Loss (PSI / BAR 100 Feet)
  • Appendix F: Cavitation
    • Figure F-1: Sample, Cavitation Regions
    • Process of Cavitation
    • Warning Signs of Cavitation (Discharge and Gauges)
      • Discharge Pressure
      • Vacuum Compound Gauge
    • To Eliminate Cavitation
    • During Operations
      • Figure F-2: Lift Loss from Temperature
      • Figure F-3: Lift Loss from Elevation
    • Preventive Measures
      • Figure F-4: Hose Size vs. Pump Rating Capacity
  • Express Warranty
    • Hale Products, Inc.
  • Addendum
  • Drawing Package
    • Customer Specific Installation / Layout Plate Drawings
• Return HOME Page
• EXIT