Off Road Unlimited 60230-D Crossover Steering 68-87 GM & 68-91 Blazer/Suburban w/Dana 44, 10-12 lift w/tie rod facing nut-down - Manual (Page 5)

ORU- Dana 44 Axle Crossover Steering System
10) When re-using the factory ball joints, inspect, press out, and re-install in the new knuckle. If
new ball joints are being used, press them into the new knuckle.
11) Reverse the previous steps for re-assembly.
12) Tighten all hardware to factory specifications.
Pitman Arm-
1) Remove factory pitman arm with a puller.
2) Install replacement arm and install factory retainer nut with loctite.
3) Torque to factory specifications.
Drag Link-
1) Assemble drag link with ends and jam nuts .
2) Once installation is complete, adjust drag link to center steering wheel, tighten jam nuts, and
grease all fittings.
WARRANTY POLICY
ORU (Off Road Unlimited), extends a lifetime warranty on their products to the original purchaser. The warranty covers
defects in material and workmanship. This warranty does not apply to wear items such as brakes, steering components,
u-joints, etc., or to products sold by, but not manufactured by ORU. Application of this warranty is subject to inspection of
the product by ORU and at their sole discretion. ORU is not responsible for shipping charges incurred to submit product
for inspection, or its return if the warranty is declined. This warranty does not cover parts that have been modified, applied
outside the intended application, or subjected to abuse. This warranty applies solely to the ORU product and does not
extend to any incidental damage(s) or incurred cost(s). No other warranties/guarantees are expressed or implied. All
warranty claims must be accompanied by the original receipt, or reasonable facsimile. To apply for warranty
consideration, contact the ORU Customer Service Department at 818-563-1208.
offroadunlimited.com
page 4
rev 07-07