Steele Products SP-HD905 - Manual (Page 4)

4
Owner’s Manual
Features
• Tip-Over Switch-shuts heater off automatically if unit tips over.
• Pilot Light – glows when heater is plugged in.
• Fan-Only Operation – allows fan to operate without heating.
Assembly
This heater comes with the handle unattached. Use the screws provided to attach handle
to the heater.
The heater is equipped with a polarized (2-blade) plug with one-blade wider than the
other.
CAUTION: The polarized plug will fit into the wall outlet in only one way. If it still does
not fit, contact an electrician to replace your obsolete outlet.
Do NOT defeat this important safety feature. To do so could result in an electric shock
hazard.
Power settings
120 V ~ 60 HZ 1500 W
TO OPERATE
1. Plug the heater power cord directly into a standard grounded 120 V outlet. Always
operate the heater in the upright position with the rubber feet on the floor.
CAUTION: Be sure plug fits tightly into outlet. A loose fit will cause overheating and
damage to the plug. Plug may feel warm during normal usage. If you must use an
extension cord with this heater, the extension cord must be at least a No.14 AWG fate
for 1875 watts.
2. Rotate wattage selector knob to the “1500W” position. This provides the maximum
heat output.
3. Rotate the “THERMOSTAT” knob clockwise (right) to the “HIGH” setting until the
knob stops. The heater should begin heating and the fan should start to blow warm air.
4. Allow the heater to operate until the room temperature reaches the desired level,
then slowly rotate the “THERMOSTAT” knob counter-clockwise (left) until the heater
cycles off. At this setting, the heater will cycle on and off automatically to maintain
this comfort level.