Steele Products SP-HO76 - Manual (Page 4)

the effect of cold drafts.
2. CONNECTION
The radiator must be connected to a properly household outlet in perfect working conditions.
Keep loose clothing or bedding, furniture and flammable material away from the wall outlet where the heater
plug is fitted in.
3. OPERATIONS AND USE
4
Owner’s Manual
1) TURNING HEATER ON:
Turn the master power switch (located below the digital control panel on the side of the heater) to the ON
position. The switch will illuminate when in the ON position. This master power switch allows power to go to
the digital controls. Operating instructions below will show you how to operate the digital controls.
2) OPERATING INSTRUCTIONS:
This heater is equipped with digital controls that provide the ability to set the temperature to the exact degree
desired. To operate, simply follow these instructions. NOTE: The temperature display will not reflect the
accurate room temperature until the heater has been operating for at least 20 minutes.
3) OPERATING INSTRUCTIONS (continued):
* Press the power button once to start the heater on High Power ( symbol), Continuous Run. If left at this
setting, the unit will run continuously on High Power and will not shut off until the unit is manually turned off.
* Press the power button again to change to Lower Power ( symbol ), Continuous Run. If left at this setting,
the unit will run continuously on Lower Power and will not shut off until the unit is manually turned off.
* Press the power button a third time to turn the heater OFF.
4) TEMPERATURE SETTING:
*Press the Temp/Timer button until the temperature icon blinks.
*Use the Up and Down arrows to set the desired temperature.
*The temperature icon will stop blinking and the current room temperature will appear after the
desired temperature is set.
*The heat will turn-off shortly after the desired temperature is reached and the temperature
display will blink.
*The heater will turn back on when the room temperature drops below the desired temperature.
The temperature display will then stop blinking and will display the current room temperature.
5) TIMER SETTING: