Heater Craft 900S Series Shower - Manual (Page 7)

Water Source
6
Questions?
Call For Technical Support
(208) 687-4400 or
Fax (208) 687-9700
www.heatercraft.com
On-Board Fresh Water System
Note: Due to viariations in boat water systems and boat sizes, the following are only general instructions.
If you are installing the shower/ wash down system to work in conjunction with the existing on-board water
system, please consult the boat manufacturer before beginning installation. If you are not installing an
additional pump for the shower system, hose connections must be made after the hot and cold lines are
pressurized.
1. Hot Water Outlet– The hot water connection should be in the water line exiting the hot water heater or
hot water source.
2. Cold Water Outlet– The cold water connection should be in the water line exiting the potable water tank.
3. Cut the water lines and install the proper size and type of hose tee for your application. The hose tee
connections should be installed in the straightest part of the hose. A section of hose may have to be
removed to prevent any kinking.