L.B. White AW100 - Manual (Page 13)

WARNING
This heater may be washed only on the external case
assembly provided:
A. The heater is disconnected from the electrical
supply.
B. All access panels are securely closed.
C. Water spray nozzle shall not discharge within 6 feet
of the heater.
D. The water pressure does not exceed 45 PSIG for 10
seconds on each side of heater.
E. The heater is not reconnected to electrical supply for
a minimum of 1 hour or until the heater is
thoroughly dry.
Improper cleaning of the heater can cause severe
personal injury or property damage due to water and/or
cleaning solution:
1. In electrical components, connections and wires
causing electrical shock or component failure.
2. On gas control components causing corrosion which
can result in gas leaks and fire or explosion from the
leak.
Clean internal components of the heater with a soft, dry
brush or cloth, or compressed air.
1. Have your gas supplier check all gas piping annually
for leaks or restrictions in gas lines. Also, at this time
have your gas supplier clean out the sediment trap of
any debris that may have accumulated.
2. The hheater’s ssurrounding aarea sshall bbe kkept cclear aand
free ffrom ccombustible m materials, ggasoline, aand oother
flammable vvapors aand lliquids.
3. Regulators can wear out and function improperly.
Have your gas supplier check the date codes on all
regulators installed and check delivery pressures to
the appliance to make sure that the regulator is
reliable.
4. Regulators must be periodically inspected to make
sure the regulator vents are not blocked. Debris,
insects, insect nests, snow, or ice on a regulator can
block vents and cause excess pressure at the
appliance.
5. Review all heater markings (ie. warnings, start-
up/shutdown, electrical wiring, diagrams, etc.) for
legibility. Ensure that none are cut, torn, or otherwise
damaged. Any damaged markings must be replaced
immediately by contacting L.B. White Co., Inc.
Markings are available at no cost.
1. Before cleaning, close gas supply valve to heater and
disconnect heater’s electrical supply.
2. The heater should have dir t or dust removed
periodically:
a. Af ter each flock or between building re-
population, give the heater a general cleaning
using compressed air or a soft brush on its
interior and exterior. At this time, dust off the
motor case to prevent the motor from over-heating
and shutting the heater down.
b. At least once a year, give the heater a thorough
cleaning. At this time, remove the fan and motor
assembly and brush or blow off the fan wheel,
giving attention to the individual fan blades.
Additionally, make sure the burner air inlet venturi
ports and the throat of the casting are free of
dust accumulation and the area between the heat
chamber top and inside case is also free of dust.
c. When washing with water, observe and obey the
Warning within these Cleaning Instructions. This
same Warning is also supplied on the heater.
13
Cleaning Instructions
Maintenance Instructions
WARNING
Fire, B Burn, aand EExplosion H Hazard
■ This heater contains electrical and mechanical components in the gas management, safety and airflow systems.
■ Such components may become inoperative or fail due to dust, dirt, wear, aging, or the corrosive atmosphere of an
animal confinement building.
■ Periodic cleaning and inspection as well as proper maintenance are essential to avoid serious injury or property
damage.