L.B. White 300 Director - Manual (Page 11)

14 10
1. Follow all ventilation and safety information.
2. Ensure electrical supply conforms to data plate
requirments.
3. Fill tank with fuel.
4. Connect heater to an approved electrical supply.
5. T h e h e a te r m ay b e o p e r a te d w i t h o r w i t h o u t
thermostat.
Without thermostat:,
-- Push the top of the ON/OFF switch ( l ) to ON. The
motor will start, followed by ignition.
-- The heater will operate until the switch is positioned
to OFF.
With thermostat,
-- Connect thermostat per instructions in this manual.
-- Push the bottom of the ON/OFF switch (ll) to ON.
-- The heater will start when thermostat is set above
surrounding air temperature.
6. When in normal operation, the Ignition control reset
button with lamp emits a GREEN light.
7. When the unit is started for the first time or is started
after the fuel tank has been totally emptied, the flow
of fuel may be impaired by air in the circuit. The
ignition control will shut the heater down. It may be
necessary to restart the heater once or twice by
depressing the “Reset” button. To ease starting,
remove the canister bottom from the pump’s fuel filter
and fill with fuel. Reassemble the filter.
Start-Up Instructions
FIG. 6
RESET BUTTON WITH
CONTROL LAMP
ON/OFF SWITCH THERMOSTAT SOCKET
AND COVER
POWER CORD
POWER INDICATOR LIGHT