Bush Hog Utility Vehicle Workshop - Manual (Page 3)

BUSH HOG ® UTILITY VEHICLE WORKSHOP MANUAL – SECTION 7: STEERING SYSTEM
7-3
TOOLS
SAFETY FIRST
CAUTION
Never work underneath a raised vehicle without adequate support. Use jack stands
to prevent the vehicle from falling. A falling vehicle can cause severe personal
injury or death.
CAUTION
When lifting a vehicle chock the wheels left on the ground to prevent the vehicle
from rolling or sliding backward.
Common hand and shop tools can be used to remove and install
steering system components serviced in the section. All special
tools are listed below.
Ball Joint Removal Tool (1.0-1.5” (25.4-38.1mm): Needed for
removal of tie rod ends from the strut casting steering arm. Ball joint
removal tools are commercially available in various sizes.