BNC 7000 Series Programmer Manual - Manual (Page 26)

26
SENSe:XX:POINTs <value>
SENSe:XX:POINTs?
Sets or gets the number of points per trace.
SENSe:XX:PPDs <value>
SENSe:XX:PPDs?
Sets or gets the number of points per decade for the trace.
SENSe:TRACe:SPURious:OMISsion
SENSe:TRACe:SMOothing:APERture
SENSe: TRACe:SMOothing:STATe
:SENSe:ASET <value>
This command sets the RF step attnuator for the selected channel.
SENSe:ASET:AUTO ON|OFF|1|0
Sets step attenuator to automatic.
SENSe:XX:AVERage:COUNt {1 ~ 9999}
SENSe:XX:AVERage:COUNt?
This command sets/gets average count.
SENSe:XX:FREQuency:STARt
SENSe:XX:FREQuency:STARt?
This command sets/gets start frequency.
SENSe:XX:FREQuency:STOP
SENSe:XX:FREQuency:STOP?
This command sets/gets stop frequency.
SENSe:PN:FREQ:SPOT
This command sets the desired offset frequency spot to be measured. Upon setting of this value, the
loop bandwidth, locking time constants, as well as fourier coefficients are calculated for highest
measurement speed.
Berkeley Nucleonics Corporation 2955 Kerner Blvd., San Rafael, CA 94901
Phone: 415-453-9955, Fax: 415-453-9956, Email: [email protected], Web: www.berkeleynucleonics.com