Poison Spyder TJ CAGE LOWER A-PILLAR KIT - Manual (Page 2)

INSTALLATION INSTRUC
TIO
NS
Poison Spyder Customs • TJ CAGE LOWER A-PILLAR KIT INSTALL Page 2
©2010 POISON SPYDER CUSTOMS, INC. • 951-849-5911 • WWW.POISONSPYDER.COM
FIGURE 2
7. Continue with the rest of your cage
fabrication. Attach the tubular upper A-pillars
of your cage to the top surface of the Poison
Spyder Lower A-Pillar. Only tack weld this
joint during initial fabrication. Wait until the
entire cage is complete, to remove the cage
and fully weld all of the seams.
8. Re-install the completed cage into the Jeep
after finish-welding and painting or powder
coating. Use the supplied 1/2-13 Gr8 hex
head cap screws, washer plates and nylon-
insert lock nuts to secure the bottom foot of
each Lower A-Pillar to the existing hole in the
floorboard of the Jeep.
Congratulations, you have completed the
installation of your Poison Spyder Lower A-Pillar
Kit!