Poison Spyder YJ FULL CAGE KIT - Manual (Page 3)

INSTALLATION INSTRUC
TIO
NS
Poison Spyder Customs • YJ FULL CAGE KIT INSTALL Page 3
©2010 POISON SPYDER CUSTOMS, INC. • 951-849-5911 • WWW.POISONSPYDER.COM
opening on either side. Re-use the factory
hardware.
11. Install the C-Pillar Mount Plates L&R 9
where the factory roll bar bolted in at the rear
corners. Orient the plates with the rounded
point edge facing the rear of the Jeep.
Secure them using the OE hardware.
FIGURE 4
7. Install the Main Side Hoops L&R 5 , one
side at a time. Have a friend hold the Main
Side Hoop in place with the front portion of
the tube centered on the top flat surface of
the Lower A-Pillar. Hold the rearward end of
the tube so that it lands centered within the
curved-point area of the C-Pillar Mount Plate.
Tack-weld the Main Side Hoop at each end.
8. Install the B-Crossbar 11 between the two
Main Side Hoops. Reference the laser-
etched markings to correctly locate the
C-Crossbar along the inner side of each
Main Side Hoop. Tack the B-Crossbar into
place.
FIGURE 8
9. Install the B-Pillars L&R 14 between the
B-Pillar Mount Plate and the Main Side Hoop
on either side. Reference the laser-etched
markings to correctly locate the B-Pillar tube
along the Main Side Hoop. Tack the B-Pillar
into place.
FIGURE 9
10. Install the A-Crossbar 13 and the Forward
Stringers L&R 11 at the same time. Have
a friend help with holding the three pieces
in place. Start by holding the A-Crossbar
in place between the two Main Side Hoops,
toward the front of the Jeep. Next, hold the
two Forward Stringers in place between the
A-Crossbar and the B-Crossbar. Use the
laser-etched marks on each of the tubes to
properly locate the tube junctions. Use the
Forward Stringers to locate the A-Crossbar
the proper distance forward from the
B-Crossbar. While holding them in place
correctly located, tack the A-Crossbar and
Forward Stringers into place.
FIGURE 10
11. Install the C-Hoop 6 and the C-Pillars L&R
16 at the same time. Have a friend help
with holding the three pieces in place. Start
by holding the C-Hoop in place, extended
rearward from the downward bend on each
Main Side Hoop. Next, hold the two C-Pillars
in place vertically between the C-Hoop and
the lower ends of the Main Side Hoop. While
UPDATED
PHOTOS
COMING SOON
!
UPDATED
PHOTOS
COMING SOON
!
UPDATED
PHOTOS
COMING SOON
!