Poison Spyder JK BRAWLER LITE FRONT BUMPER - Manual (Page 2)

INSTALLATION INSTRUC
TIO
NS
©2013 POISON SPYDER CUSTOMS, INC. • 951-849-5911 • WWW.POISONSPYDER.COM
Poison Spyder Customs • JK BRAWLER LITE FRONT BUMPER Page 2
disconnect the wiring harness plugs from the
sockets at the back of each lamp. A small flat
head screwdriver may be useful to release
the tangs on the plug
4. Use a ratchet and 19mm deep socket to
remove the eight (8) nuts that fasten the
bumper to the frame. There are two of these
nuts on the inner side, and two on the outer
side, of each frame rail where it joins the
bumper.
FIGURE 3
With these nuts removed, remove the
bumper from the Jeep.
FIGURE 4
5. If your Jeep is equipped with factory fog
lamps, these may be removed from the stock
bumper and re-installed into the Brawler
Lite bumper. Use a Phillips screwdriver to
remove the four (4) retaining screws from
each lamp, on the back side of the bumper.®
FIGURE 5
Install the factory fog lamps into the fog lamp
mounts in the back side of the Brawler Lite
bumper. Re-use the OE retaining screws.
These sheetmetal screws will form their own
threads as you drive them into the retaining
rings on the RockBrawler bumper, so press
firmly as you twist the screwdriver.
FIGURE 6
6. Remove the plastic top bumper cover.
You may be able to remove the two plastic
screws with a Phillips screwdriver. But it is
likely they’re “frozen” in place and will have to
be pried up with the push-in retainer removal
tool.
FIGURE 7