Poison Spyder JK BRAWLER ROCKERS - Manual (Page 3)

INSTALLATION INSTRUC
TIO
NS
©2010 POISON SPYDER CUSTOMS, INC. • 951-849-5911 • WWW.POISONSPYDER.COM
Poison Spyder Customs • JK BRAWLER ROCKERS INSTALLATION Page 3
FIGURE 4
2. Use the 1/4” bit and drill motor to drill the
first two mounting holes using the Body
Armor Upper Piece as your drill guide. Use
the forward and rearward most holes. Make
sure you do not drill through the inner panel.
3. Remove the Body Armor Upper Piece from
the Jeep and set aside.
4. Use the 25/64th drill bit and open up the two
holes you just drilled. Take your time drilling
these holes, the larger drill bit may catch and
distort the hole. Make sure you do not drill
through the inner panel.
5. Apply some touch up paint to the areas
where bare metal is exposed; this will aid in
the prevention of corrosion.
6. Using the nut insert tool and the separate
instructions provided, install nut-serts into
the holes you just drilled. Do not over tighten
the nut inserts; this will cause them to distort
and not fasten to the body correctly.
FIGURE 5
7. Install the Body Armor Upper Piece using
two 1/4” flat head bolts. Make sure you place
a small amount of anti-seize on each bolt. Do
not over tighten the bolts; for this step you
will only need to snug them up.
8. Double check the fitment to make sure you
are happy with it.
9. Using the 1/4” drill bit, drill the rest of the
mounting holes using the Body Armor Upper
Piece as your drill guide. Make sure you do
not drill through the inner panel.
FIGURE 6
10. Remove the Body Armor Upper Piece and
set aside.
11. Use the 25/64th drill bit and open up the
holes you just drilled. Take your time drilling
these holes; the larger drill bit may catch and
distort the hole. Make sure you do not drill
through the inner panel.
12. Apply some touch up paint to the areas
where bare metal is exposed; this will aid in
the prevention of corrosion.
13. Using the nut insert tool, install inserts into
the holes you just drilled. Do not over tighten
the nut inserts; this will cause them to distort
and not fasten to the body correctly.
14. Remove the tape from the back of the Body
Armor Upper Piece.
15. (Optional) If you purchased the rubber
liners, they will need to be placed on the
back side of the Body Armor Upper Piece.
Use a couple of bolts to help hold the liner in
place.