DTS surround encoder - Manual (Page 5)

3. Install the adapter key (dongle) (DTS #E907-02) into a USB port on
your PC
after the software has completed installation.
Note: It is the responsibility of the owner of the DTS Pro Series Surround
Encoder to keep the adapter key (dongle) in a safe and secure location. If the
adapter is lost, DTS has no obligation to replace it.
If the adapter is damaged or malfunctioning, DTS will replace the adapter at
no charge during the warranty period. If the adapter is damaged after the
warranty period, a service charge will apply.
1.2. Mac Standalone Installation
System requirements
■
Apple computer, Power PC G4 or higher (Dual Processor G5 recommended)
■
256 MB RAM
■ 1 hard drive, 7200 RPM minimum
■ 100 MB free disk space
■ Greater than 20 GB recommended for audio files
■
USB port for the license adapter (dongle)
Surround Encoder requirements
■
Mac OS X version 10.3.5 or higher
■
Java Runtime 1.4.1 or higher
There are patches available at:
http://www.apple.com/downloads/macosx/apple/
to install these two (above) to OS X version 10.2.
■
Runtime for the adapter key dongle (WIBU, a third party)
Surround Encoder installation procedure
Preparation
The Surround Encoder is an application for OS X versions 10.2.8 onwards,
with Java 1.4.1 already installed. OS X versions 10.3 and higher already have
Java 1.4.1 installed.
If your version of OS X is before 10.2.0, you will need to purchase an upgrade
to version 10.2 or higher.
If your version is higher than 10.2 but lower than 10.2.8, upgrade to the latest
version with the
Software Update utility or an update patch.
Once the operating system is at version 10.2.8 or higher, you will be able to
upgrade to Java 1.4.1. This can be done with the
Software Update utility
or an update patch.
Installation and User Manual – DTS Pro Series Surround Encoder
3