Hyline Offroad XJ LOUVERED HOOD PANEL User Manual
Page 4
T:\Hyline Offroad, LLC\Installation Instructions\XJ-50HLP\XJ-50HLP Installation Instructions.doc
Page
4
of
4
REV 0 05/20/10
**NOTE** You will need to use the 1” hole saw to expand
4 holes under the hood in the support channels in
order to attach the nut to the stud. See (Figure 3)
Step 10 – Once drilling is completed, Use 1” Hole saw and drill each corner of the 6 cutouts (24 times total).
Step 11 – Now you can use a jigsaw or cutoff wheel to trim out the cutouts. Simply follow the lines you traced
from the template. After drilling and cutting, use the file to deburr and clear spray paint to prevent rust.
Step 12 – Install the Left Hood Louver Panel onto hood and assemble nylon locknuts to threaded studs using the
3/8” socket. Tighten the nuts just enough until they touch the steel hood.
DO NOT OVERTIGHTEN NUTS! OVERTIGHTENING WILL
CAUSE DISTORTION OF PANEL!
Step 13 – Follow the same process as in Step 12 and install the Right Hood Louver Panel. Reinstall your hood
onto the Jeep, reattach the hood release cable and you’re done.
Send your OFFROAD pictures to
. If we choose any one of your pictures to be used
on our website, We send you a FREE Hyline Offroad T-Shirt.
Installation instructions provided must be read and followed exactly when installing
product. Failure to do so could potentially result in injury or death of any occupants
in the vehicle. WEAR SEAT BELTS AT ALL TIMES WHEN DRIVING!
Though our products are rugged, they are primarily designed and built to enhance the appearance of the
vehicle and will not protect from death or injury in the event of an accident. Adhere to all vehicle
manufacturers specifications
Attention
Figure 3