Hyline Offroad YJ LOUVERED HOOD PANEL - Manual (Page 2)

*** BEFORE INSTALLING ***
If you ordered the Hood Louver Panel raw you should paint, anodize, powder coat, etc. now before
installation onto vehicle. PEEL OFF THE VINYL PROTECTANT COVERING BEFORE PAINTING OR
FINISHING. If Hood Louver Panel was was ordered black powder coated your now ready to continue
to step 1.
Hood Louver Panel Installation
Step 1 – As a safety precaution - Remove the hood from your vehicle before drilling or cutting. First, remove the
engine grounding strap, hood light, and/or windshield washer hose from hood, if applicable. Then unbolt
the 4 bolts from the hood hinges. Hood should now be free to remove from vehicle.
Step 2 – Once the hood is removed, place the hood on a flat, solid work area. Then remove the windshield
u-shape tie down bracket and windshield bumper brackets. Brackets unbolt from under the hood.
Step 3 – Place steel template in the center of hood as seen
in (Figure 1). **Picture may vary from your Template.**
Visually make sure the holes in the template are centered
with the holes for the windshield tie down bracket and
the template is exactly where you want it.
Step 4 – Without moving the template re-install the U-Shape tie down
bracket and tighten nuts securely, as these will hold the
template in place while drilling in Step 6.
T:\Hyline Offroad, LLC\Installation Instructions\YJ-50HLP\YJ-50HLP Installation Instructions.doc
Page 2 of 4
REV 0 06/17/09
PLEASE READ INSTRUCTIONS BEFORE BEGINNING INSTALLATION
Figure 1