Hyline Offroad JK TUBE STEP ROCKER PANELS (2 DOOR MODELS) - Manual (Page 2)

Q:\Hyline Offroad, LLC\Installation Instructions\400.300.110-JK ROCK SLIDER (2 DOOR)\400.300.110 Installation Instructions.doc Page 2 of 4
REV 1 1/21/14
1. Remove any stock rock rails or factory tube steps from vehicle if equipped.
Passenger Side Installation:
2. Remove the two existing bolts from underside of frame rail. This should drop the skid plate crossmembers just
enough to slide the Passenger Side steel drill template in place. The Passenger Side Template will have a GREEN
Dot located on it.
3. Insert the Passenger Side steel drill template between skid plates and
the frame rail. Reinstall the two existing bolts and tighten.
(Figure 1)
4. You can now drill the 4 holes in the side of the frame through the
template using a 3/16” Drill Bit. Using a smaller drill bit will help
with accuracy before drilling the final size 1/2” hole size.
5. After all 4 holes are pre-drilled you can remove the template.
Then redrill all 4 holes open to 1/2”. A Multi-Depth or Step Drill
Bit is nicer for this operation because it’s shorter and will cut through
the metal quicker and easier.
6. Before you install the Rock Slider onto your Jeep you may need to loosen more of the bolts on the gas tank skid plate
and transmission skid plate in order to fit the Rock Slider Brackets in between the skid plate crossmembers and frame
rail. You’ll need atleast a ¼’’ gap or more to make fitting in the Rock Slider Brackets much easier.
Note: You will also need to remove the
factory Rubicon Rails if vehicle is
equipped with them.
Figure 1, Template Shown is For 2 Door