Hyline Offroad TJ/YJ REAR SWINGOUT TIRE CARRIER ASSEMBLY - Manual (Page 2)

Generation II Swingout Tire Carrier Installation
Step 1 – If you have not already installed your Hyline Offroad Rear Bumper that accepts this tire carrier please do
so using the Installation Instructions for P/n 250.200.110.
***BEFORE INSTALLING TIRE CARRIER ON THE BUMPER COMPLETE STEPS 2 & 3***
Step 2 – Remove the stock tire carrier housing by unbolting the four bolts using the ½” socket. Then remove the 3 black
rubber mounts that the stock tire pressed against using the torx socket. Cut wire for third brake light as long as
possible for rewiring if desired.
Step 3 – Install the Stainless Steel Grease Fitting using the 7/16” Wrench.
The grease fitting has pipe threads which are tapered to obtain
a leak free seal. Because of the tapered threads you may not
be able to completely screw in the grease fitting. Note: Location of
fitting might vary from picture in Figure 1.
Step 4 – Install the supplied tailgate bracket using 3 bolts that were previously
removed from stock tire carrier (Do Not Tighten Yet). Install Rod End
Fitting using 3/8” flat washers & 3/8”-24 Locking Hex Nut & tighten.
Also install the white plastic Alignment block using two-5/16-18” bolts,
four-5/16” flat washers & two-5/16-18” hex lock nuts (Do Not Tighten Yet).
See Figure 2 – Photo May Vary By Model
PLEASE READ INSTRUCTIONS BEFORE BEGINNING INSTALLATION
Figure 2
Note: Two Plastic Alignment Blocks have been provided. Use whichever block works best to align swingout carrier parallel to the tailgate.
Typically all models will use the shorter block.
Brass Washers
& Grease Fitting
Figure 1
Tailgate Bracket