Bosch WTMC6521UC - Manual (Page 24)

24
Degree of drying has not been reached
or the drying time is too long.
Display may indicate E:03". Moisture sensor dirty. Clean moisture sensor as described on page 22.
Switch off/switch on again.
or the drying time is too long.
Display may indicate E:03".
Exhaust air duct is blocked or too long. Clean exhaust air extraction. Reduce exhaust air duct
to maximum length as described on page 8.
Switch off/switch on again.
Lint filter dirty. Clean filter as described on page 22.
Switch off/switch on again.
Laundry was too wet. Spin laundry at higher speed in the washing
machine. Switch off/switch on again.
Unsuitable program selected. Select program with aid of the program selection
table (see page 18). Switch off/switch on again.
Maximum drying time was exceeded. Clean lint filter (see page 22).
Check exhaust air extraction.
Spin laundry at a higher speed in your washer.
Motor limit temperature was exceeded. Switch off dryer, leave to cool down for 30 min.
Switch on again. Start program.
Degree of dryness not correct set. Change settings for degree of dryness, see page 15
Lint filter LED is blinking after lint filter
has been cleaned Blinking of lint filter LED is not an indication of a
problem. It is used only as a reminder. No action required. Light will stop blinking.
SERVICE and REPAIR
d CAUTION d
CAUTION - Label all wires prior
to disconnection when servicing
controls. Wiring errors can cause
improper and dangerous
operation. verify proper
operation after servicing.
The Bosch dryers require no special
care other than the care and cleaning
noted above.
i If you are having a problem with
your dryer, before calling for
service please refer to Table on
page 23, following.
If service becomes necessary, contact
your dealer or installer or an authorized
service center. Do not attempt to repair
the appliance yourself. Any work
performed by unauthorized personnel
may void the warranty.
If you are having a problem with your
Bosch dryer and are not pleased with
the service you have received:
-
First, please contact your installer
or the Bosch Authorized Service
Contractor in your area and
explain to them why you are not
satisfied. This will usually correct
the problem.
- If after working with your installer
or service person the problem still
has not been resolved to your
satisfaction, please let us know by
either writing to us at,
BSH Home Appliances
5551 McFadden Avenue
Huntington Beach, CA 92649
or, calling us at
1Ć800Ć944Ć2904.
Please be sure to include, if writing, or
have available, if calling, the following
information:
-
Model Number
- Serial Number
- Date of Original Purchase
- Date Problem Originated
- Explanation of Problem
Also, if writing, please be sure to
include a daytime telephone number
and a copy of the sales invoice.
You will find the model number and
serial number information on the rating
plate located on the inside of the front
panel.