Class1 Digital speedometer - Manual

page 1 of 4 pages
Engineering
Standards
Name
Identifier OEM Installation and Calibration
Engineering Standard Number
C1-102007-A
Digital Speedometer Information
1. Scope
This document addresses the Class1 digital speedometer and the installation, cali-
bration, and operation of this unit.
2. Purpose
The purpose of this document is to provide the OEM with enough information to allow
him to install this device and provide it to the end user fully operational and calibrated.
3. Display Installation
The speedometer display mounts in a by 2.84” by 1.51” cutout.
Overall area necessary for installation is 3.2” by 2.5” and a depth of 5 inches.
Two 0.201 diameter holes are provided for mounting screws.
2.840"
.277
1.510
.470 1.900
Ø 0.201"
(2) HOLES