Apple Xserve Intel (Late 2006) DIY Procedure for Optical Drive Cable - Manual

073-0778 Rev. B
 Xserve/Xserve G5
Optical Drive
Replacement Instructions
Follow the instructions in this sheet carefully. Failure to follow these instructions could
damage your equipment and void its warranty.
Online instructions are available at http://www.info.apple.com/installparts/.
Note: These instructions apply to the optical drive of different versions of Xserve/Xserve
G5. Your server may look slightly different from the one shown in the illustrations.
Tools Required
The only tool required for this procedure is a jeweler’s Phillips (#0) screwdriver.
Opening the Server
The server slides open from the front of the rack. The top cover remains in place in the
rack while the bottom housing (containing all internal components) should be placed on a
sturdy, flat surface.
1. Alert users that the server will be unavailable for a period of time.
2. Shut down the server.
Warning: To avoid damaging internal components or causing injury, always
shut down the server before opening it. After you shut down the server, internal
components can be very hot. Let the server cool down before continuing.
3. Write down the server’s serial number, which is located on the back panel. If it is
necessary to set up the server’s software after you replace the optical drive, you will
be asked for the serial number at login.