MBW 5800 Series - Manual (Page 8)

- 5 -
M
AINTENANCE
WARNING
Always exercise the stopping procedure before
servicing or lubricating the unit.
After servicing the unit, replace and fasten all
guards, shields, and covers to their original
positions before resuming operation.
CAUTION
Always verify fluid levels and check for leaks after
changing fluids.
Do not drain oil onto ground, into open streams,
or down sewage drains.
Maintenance Schedule
1. Check all hardware after the first 5 hours of use, then follow the maintenance schedule.
Fluid Levels
1. MBW #01058---- 6-Pack (8 oz. bottles)
MBW #17320---- 1 quart (32 oz.)
Engine Maintenance
Refer to the engine Owner’s Manual for maintenance
intervals and procedures.
Engine Speed
1. Engine speed is factory set according to the speeds
listed in the Specifications section of this manual. Do
not tamper with the governor setting.the governor
establishes safe operating limits which must not be
exceeded.
2. Refer to the engine Owner’s Manual for procedure on
setting operating and idle speed.
3. The engine operating speed should be set to 3400
RPM.
4. The engine idle speed must not exceed 1800 rpm. If
the idle speed is greater than 1800 RPM the clutch
may not disengage.
Cleaning Plate
Remove any excess debris which may get into the housing
of the unit.
Belt Adjustment
If any belt stretch develops follow these steps:
Refer to ROLLCAGE ASSEMBLY, page 16.
1. Remove 2 hex head flange bolts (#10) securing belt
guard to roll cage & engine deck and remove belt
guard. (See figure 1)
SYSTEM MAINTENANCE EACH USE
EVERY 50
HOURS
EVERY 250
HOURS
YEARLY
Engine Refer to engine operator/owner manual X
Exciter Check oil level X
Check for oil leaks X
Change oil X X
Tighten Bolts
1 X X
Hardware Check and tighten as needed 1 X X
Shockmounts Check for cracks or tears X X
SYSTEM FLUID VOLUME RECOMMENDED OIL
Exciter 6 oz. MBW Ground Pounder
®
Exciter Oil
1
Engine Refer to engine operator/owner manual