Maintenance, Maintenance schedule, Fluid levels – MBW F24/4 User Manual
Page 8: Engine maintenance, Engine oil, Engine speed, Cleaning, Lifting, Storage, Changing trowel blades
- 5 -
M
AINTENANCE
WARNING
Always exercise the stopping procedure before
servicing or lubricating the unit.
After servicing the unit, replace and fasten all
guards, shields, and covers to their original
positions before resuming operation.
CAUTION
Always verify fluid levels and check for leaks after
changing fluids.
Do not drain oil onto ground, into open streams,
or down sewage drains.
Maintenance Schedule
1.
Check all hardware after the first 5 hours of use, then follow the maintenance schedule.
Fluid Levels
Engine Maintenance
Refer to the engine owner’s manual for maintenance
intervals and procedures.
Engine Oil
Refer to the engine owner’s manual for recommended oil
change intervals.
WARNING
Never change the oil when engine is hot. Always
wear protective gloves when working with engine
oil.
To drain the oil place a drain pan underneath the engine and
remove the drain plug. After the oil has finished draining,
reinstall the plug and clean any spilled oil from the trowel.
Engine Speed
The engine speed is factory preset according to the
Specifications section. Do not tamper with the governor
settings. The governor establishes safe operating limits.
These limits must not be exceeded.
Cleaning
Always clean the trowel thoroughly after each day’s
operation. Dried concrete buildup can hinder performance
and shorten the life of the trowel.
Lifting
The trowel should be lifted by two people. A secondary
handle for lifting is provided at the front of the trowel.
Storage
The trowel should be stored with blocks supporting the outer
guard ring. Refer to the engine owner’s manual for
information regarding storage of the engine.
Changing Trowel Blades
WARNING
Trowel blade edges may be sharp when they are
worn. Wear protective gloves when handling the
blades.
1.
Set the trowel on a level surface.
2.
Remove the bolts securing the blade to the tilt arm.
MAINTENANCE
10 HOURS OR
DAILY
50 HOURS OR
WEEKLY
100 HOURS OR
MONTHLY
500 HOURS OR
YEARLY
Inspect drive belt
X
Check and tighten all hardware
1
X
SYSTEM
FLUID VOLUME
RECOMMENDED OIL
Engine
Refer to engine operator/owner manual