Stopping engine, Stopping in emergency conditions – MBW MK8 120 User Manual
Page 8
- 5 -
subsequent smoothing operations continue increasing the
blade inclination until obtaining the desired finish.
The time between one pass and the next is determined by
the temperature and by the amount of water in the concrete.
If the concrete has hardened too quickly in some areas, it
can be moistened by spraying a small amount of water
using the button located on the left control bar in order to
obtain the degree of finish desired.
Stopping Engine
1.
Release the accelerator pedal to idle and release the
two safety stop levers.
2.
Close the fuel valve and remove the start key from
the engine.
Stopping in emergency conditions:
The safety stop levers are connected to two micro switches
which cut the electric power to the engine; in case of an
emergency, immediately release the levers.
WARNING
Always stop the engine before:
Adding fuel.
Leaving the equipment unattended for any
amount of time.
Before making any repairs or adjustments to the
machine.
Fig. 1, Control
Moving Forward
Push both control levers forward.
Moving Backwards
Pull both control levers back.
Moving to the Right
Push both control levers right.
Moving to the Left
Push both control levers left.
Right turn
Push the left control lever forward
and pull the right control lever back.
Left turn
Push the right control lever forward
and pull the left control lever back.