MBW BMS95 - Manual (Page 8)

- 5 -
M
AINTENANCE
WARNING
Always exercise the stopping procedure before
servicing or lubricating the unit.
After servicing the unit, replace and fasten all
guards, shields, and covers to their original
positions before resuming operation.
CAUTION
Always verify fluid levels and check for leaks after
changing fluids.
Do not drain oil onto ground, into open streams,
or down sewage drains.
Maintenance Schedule
1. Applies to BMS95 only.
2. Check all hardware after the first 5 hours of use, then follow the maintenance schedule.
Fluid Levels
Engine Maintenance
Refer to the engine owner’s manual for maintenance
intervals and procedures.
Engine Speed
The engine speed is factory preset according to the
specifications section of this manual. Do not tamper with the
governor settings. The governor establishes safe operating
limits which must not be exceeded.
Cleaning
1. Cleaning of pump and equipment, refer to
manufacture’s literature of each chemical being
sprayed for proper cleaning instructions and cleaning
agent. Do not allow spraying solution to dry in the
pump. Failure to properly clean sprayer will void
warranty.
Winterizing
Winterize your sprayer when temperatures may drop
below freezing.
1. Drain and thoroughly clean pump.
2. Fill pump with a 50/50 water and antifreeze mixture.
SYSTEM MAINTENANCE EACH USE WEEKLY
EVERY 100
HOURS
YEARLY
Engine Refer to engine operator/owner manual X
Oil
Check oil levels in engine gear reducer and
pump if applicable
X
Pump Clean and flush pump X
Pump Replace diaphragms
1 X
Hardware Check and tighten hardware as needed
2 X
SYSTEM ENGINE/GEAR REDUCER PUMP
RECOMMENDED
OIL
BMS74 &
BMS75
Engine/Gear reducer refer to
operator/owner manual
N/A See manual
BMS95
Refer to engine/pump operator/
owner manual
Refer to pump operator/owner
manual
Hypro formulated
pump oil