Lukas WP60EEC - Manual (Page 2)

2
Instruction Manual
Column Press with Electric Pump “WP60EEC”
INDEX
1. BEFORE USING THE EQUIPMENT ................................ 2
2. TECHNICAL FEATURES ................................................. 2-3
3. ESSENTIAL SAFETY REQUIREMENTS ......................... 3-4
4. TRANSPORT AND INSTALLATION ................................ 4
5. START
UP ........................................................................ 5
6. MAINTENANCE, PROBLEMS AND SOLUTION ............. 6
7. WARRANTY ..................................................................... 6
8. CE - DECLARATION OF CONFORMITY......................... 7
1. BEFORE USING THE EQUIPMENT
Before unpacking the equipment check for:
1- Oil leaks, signs of corrosion.
2- Damage to the hydraulic cylinder or hydraulic line.
3- Damages in the frame and the accessories.
4- Damages or lack of screws and connections.
5- Damaged or incorrectly assembled accessories.
If you observe any fault or damage in the equipment, avoid its use and store it in a safety place until be repaired by an authorized service dealer.
Never use hydraulic equipment that is damaged or suspected to be in poor condition.
The operators have to familiarize themselves with the equipment before using the machine. Read and observe exactly the instructions and the
recommendations included in packaging. Any inadequate use of the equipment not observed in the present manual or the omission of this one, may
cause serious personal and material damages, which LUKAS will not be responsible in any case.
Do not loose the instruction manual.
Do not work with the equipment near open flame, explosives, heat sources or any other source that may produce fire or cause damages to the
equipment. The equipment must not be exposed to temperatures higher than 60ºC when in use or when stored.
If purchasing a cylinder or pump for use in the press, which is not an original spare part, ensure that you are using the proper combination of pump,
cylinder and press frame before assembling the unit. In this case, we recommend you to ask for professional advice from LUKAS direct.
When you have located a good place for the press, assure that it is in solid and flat ground. The entire base of the press must be supported. If there is
any doubt about the stability, it is recommended distributing the weight (weight of press, accessories and max. additional weight of the components
which should be pressed) over a larger area, e. g. by placing sufficient large and stable steel-plates under the base of the press.
Store the press with the piston fully retracted. In order to have the press correctly storage, we recommended protecting the cylinder with a plastic film or
locating the press in a clean place, so neither the press nor their components could be damaged
.
2. TECHNICAL FEATURES
HYDRAULIC CYLINDER
•
Max. pushing capacity (t) 60 t
•
Max. operating pressure (MPa) 70 MPa
• Hydraulic stroke (mm) 180 mm
• Effective area (cm ²) 86.59 cm ²
•
Oil capacity (cm³) 1558.6 cm³
•
Extension speed, without load (mm/s) 5.7 mm/s
•
Extension speed at maximum pressure 1 mm/s
POWER PACK:
• Tank capacity (l) 6 l
• Low pressure oil flow. Rapid advance 3 l/min.
•
High pressure oil flow. Working 0.56 l/min
• Maximum operating pressure (MPa) 70 MPa
•
Maximum pressure in retraction (MPa) 10 MPa
• Distribution valve 4 ways / 3 positions hand valve
• Motor 0.75 kW; 380/220 V; 50 Hz.; 3-phase current