JUN-AIR OF1202 series [cabinet] - Manual (Page 6)


Installation
Your JUN-AIR compressor is easy to operate. Observe the
instructions and you will get many years service from your
compressor.
Visually inspect unit for shipping damage, contact your
supplier immediately if you think the unit may have been
damaged.
Check that the performance of the compressor matches
the actual air consumption, please refer to Technical
specifications.
Check that the rating plate of the compressor corresponds
with the electrical voltage offered and check that fusing is
adequate.
Placing
Place the compressor in a dustfree, dry and cool, yet frostfree
room.
Sufficient cooling from the surroundings is important.
Ambient temperature: 0°C - 40°C, 2°F - 104°F
Relative humidity: Max 90%
Mount the two distance bolts (1) on the back of the cabinet to
ensure sufficient ventilation.
1
2

5
4

1
Installation
Mount the drain bottle (2) visibly outside the cabinet and
mount the hose at the back of the cabinet ( ).
Connect the cable at the back of the cabinet(5).
Plug the compressor into a standard outlet switch.
Connect equipment at the back of the cabinet (4).
The front wheels are delivered with brakes. Brake the wheels
before starting the compressor ().
•
•
•
•
•
•
•
•
•
•
Thermo switch
The fans are controlled by a Stego thermo switch adjusted to
0°C from the factory – do not alter this setting. Check that the
setting is correct and adjust if necessary.
The fans will start when the temperature inside the cabinet
exceeds 0°C and will run continuously until the temperature
drops below 0°C.
Operating manual
GB