Synergy 4034 - Air Compressor Bracket 12+ JK w/ 3.6L Pentastar - Manual

SYNERGY MFG. 870 INDUSTRIAL WAY, SAN LUIS OBISPO, CA (805) 242-0397
INSTALLATION INSTRUCTIONS
PPM-4034 JEEP JK COMPRESSOR MOUNT KIT
2012- Present 3.6L Pentastar
GENERAL NOTES:
• These instructions are also available on our website at
www.synergymfg.com Check the website for any updated instructions and
additional photos for reference.
Installation time 20 minutes to 1 hour.
Kit contents: (1) Compressor Bracket (7) Zip Ties (1) Hose and Fitting
Required Tools:
- 13mm Wrench (preferably a ratcheting wrench)
- Philips Head Screw Driver
- 13mm Socket and ¼” ratchet with long extensions - Small Crescent Wrench
Advisory: Do not bump, or pull the master cylinder away from the booster during this install. Doing so
will dislodge the booster O-Ring. If the O-Ring becomes dislodged, do not drive the Jeep and contact
tech support for additional information.
1. Using firm pressure and pushing as indicated in the following picture, bend the rigid A/C hose
toward the engine, in order to provide clearance for the bracket.
Using fasteners and
fittings supplied with
your compressor kit,
and thread locker
assemble the
compressor on the
bracket, as indicated in
this picture:
Use thread sealant for
proper installation.
Teflon tape is not
recommended. Properly
sealed, recommended
torque is 12 to 15 ft. lbs.