Micropump GC Series Service Instructions - E Mount (Industrial Mounts) - Manual

MICROPUMP, INC.
A Unit of IDEX Corporation
PO Box 8975, Vancouver, WA 98668-8975 • Phone: 360/253-2008 • Fax: 360/253-8294
MICROPUMP LIMITED
A Subsidiary of Micropump, Inc.
Howard Road, Eaton Socon, St. Neots, Cambridgeshire, PE 19 8ET England, • Phone: (44) (0) 1480-356600 • Fax: (44) (0) 1480-356300
REVISION
LTR. DESCRIPTION DATE BY
A ORIGINATED FOR E14147. 12/19/03 LFK
PART NUMBER: L23104
MOD: GC SERIES INDUSTRIAL MOUNTS (E, K, 3, 4, 5, & 6)
SERVICE INSTRUCTIONS: L23104
GENERAL:
1. All service work should be performed in a clean area.
2. Care should be taken to avoid scratching any sealing surfaces or allowing metal chips to
come in contact with the driven magnet assembly.
3. An even, light coat of high vacuum silicone grease (Dow Corning or equiv.) should be applied
to all seals or O-Rings.
4. O-Rings with chamfers should always be installed with the chamfer up, away from the groove.
5. All assembly screws should be tightened evenly and in an alternating pattern.
6. Only Micropump factory authorized replacement parts should be used when servicing any
Micropump products.
SPECIFIC:
1. Engage Spring (2) half loop into Driving Gear Shaft (3) slot and rotate Spring/Shaft assembly
clockwise while pressing into Pump Body (1) as shown. Firmly seat Spring/Shaft assembly
into hole.
2. Orient Driven Gear Shaft(s) (4) to allow the step to engage with Suction Shoe(s) (5)
permitting the Suction shoe to seat flat against the Pump Body (1) face.
3. Torque assembly Screws (6) to 40 in/lbs.
4. Gears and Suction Shoe(s) should always be replaced in matched sets.