Smittybilt 17492 Bolt-On Fender Flares - Manual (Page 2)

WWW.SMITTYBILT.COM
For Technical Support/Warranty Information please call 310-762-9944
Smittybilt, 400 West Artesia Blvd, Compton, CA 90220
Installation Instructions
Bolt-On Fender Flares
Dodge Ram 2500/3500 (10-12)
Part #17492
STEP 5: For models equipped with factory fender
flares, removal of factory flares is required, please
consult the vehicle service manual for factory fender flare
removal.
STEP 6: Clean the body areas where the Fender
Flares will makes contact. Use the supplied alcohol wipe.
STEP 3: Pulling at right angles to the extrusion,
remove the liner from the extrusion in small portions and
apply thumb pressure to ensure that it adheres to the
Fender Flares.
STEP 4: Cut notches in extrusion tape to allow it to fit
neatly around headlamp area of flare as shown.