Smittybilt 55054 Bull Bar - Manual (Page 2)

For Technical Support/Warranty Information please call 310-762-9944
Smittybilt, 400 West Artesia Blvd, Compton, CA 90220
Page 2 of 4
Installation Instructions
Bull Bar (#55053&55054)
04-09 Ford F-150/ 03-08 Expedition/
07-08 Lincoln MK-LT
the front of the Mounting Bracket. Secure with (1) 12mm Lock Washer, (1) 12mm x 24.1mm
OD x 2.1mm Flat Washer and (1) 12mm Hex Nut. Snug but do not tighten the hardware at this
time.
NOTE: It may be necessary to remove the lower plastic portion of the bumper to gain access to
the ends of the frame rails. The indented pockets in the lower bumper will need to be cut out to
allow the Mounting Brackets to pass through.
4. Repeat Step 3 for the passenger side Mounting Bracket installation.
5. With help position the Bull Bar on the inside of the Mounting Brackets. Use the included (4) 12mm x
35mm Hex Bolts, (4) 12mm lock Washers, (8) 12mm Flat Washers and (4) 12mm Hex Nuts to attach
the Bull Bar to the Mounting Brackets, (Fig 3). Do not tighten at this time.
6. Align and adjust the Bull Bar properly, and tighten all hardware.
7. Do periodic inspections to the installation to make sure that all hardware is secure and tight.
To protect your investment, wax this product after installing. Regular waxing is recommended to add a
protective layer over the finish. Do not use any type of polish or wax that may contain abrasives that could
damage the finish.
For stainless steel: Aluminum polish may be used to polish small scratches and scuffs on the finish. Mild soap
may be used also to clean the Bull Bar.
For gloss black finishes: Mild soap may be used to clean the Bull Bar.