Smittybilt FN1730-S4 Sure Steps - Manual (Page 4)

Driver Side Installation Pictured
Page 3 of 4
Offset Double Bolt Plate
10mm Lock Washers
10mm Flat Washers
10mm Hex Nuts
Align holes in brackets
with holes in pinch weld.
Secure with:
8mm x 25mm Hex Bolts
8mm Hex Nuts
8mm Lock Washers
8mm Flat Washers
Centered Double Bolt Plate
through top slots in
Mounting Bracket
10mm Lock Washers
10mm Flat Washers
10mm Hex Nuts
Front
(Fig 3) Front Mounting Bracket installation
Rear
Narrow Double Bolt Plate
(driver side 3-Door model only)
Pictured with Plastic Retainer
(Fig 4) Rear Mounting Bracket installation
(except driver side Mounting Bracket on
97-98 3-door models)
Thread Plastic Retainers until
tight against sheetmetal
Fig 5
Fig 6
Narrow Double Bolt Plate uses
(2) lower slots on Mounting
Bracket (driver side 3-Door
model only)
1/2" x 2" Hex Bolt
1/2" Lock Washer
1/2" Flat Washer
Fig 7