Smittybilt 76653 Rear Bumper User Manual

Rear bumper template instructions

Advertising
background image

For Technical Support/Warranty Information please call 310-762-9944

Smittybilt, 400 West Artesia Blvd, Compton, CA 90220

Rear Bumper

Template Instructions

(76750, 76750D, 76651, 76651D,76653)



Step 1:
Raise the frame drill template into place by locating it on the rear frame
cross member OE bumper outer mounting holes. NOTE: The notch will be on the top and the
drill template will be flipped for use on both the driver and passenger side.


Step 2:
Using the supplied drill template, making sure its straight mark the needed holes with a scribe or
marker then proceed to drill the (4) holes in the frame using a 7/16” drill bit.





CAUTION!

Be VERY CAREFUL not to drill into the fuel tank. Use a drill stop on

the drill bit to prevent the drill bit from over penetrating.

Advertising
This manual is related to the following products: