Smittybilt SB76622 SRC Bumper - Manual (Page 3)

For Technical Support/Warranty Information please call 310-762-9944
Smittybilt, 400 W Artesia, Compton, CA 90220
Revised 12.1.09
Installation Instructions:
SRC Bumper (Part # SB76622)
2007 Jeep JK SRC Rear Bumper
w/ Tire Carrier
Step 6: Install the (4) ½” X 1 ¼” into the previously installed nut plates (90-3925), (2) on
the driver’s side, (2) on the pass side. Level the bumper and torque the bolts to 90 ft./lbs. (Fig
E)
(Fig E)
Step 7: Torque the (4) hitch plate bolts to 90 ft./lbs. (Fig D)
Step 8: Place nylon washer over rear bumper post, then place tire carrier on top, then an-
other nylon washer. Once the tire carrier has been placed over post, swing it to the closed posi-
tion and latch it into place. Secure it with the already installed bolts (No Washers). (Fig F and
G) IMPORTANT!: Over-tightening the pinch bolts will not allow the tire carrier to swing
freely.
(2) 1/2”
X 1 1/4”
Bolts
Pass side view
(Fig G)
3/8” X 1
3/4”
Bolts
(Fig F)