Smittybilt SB76612 SRC Bumper - Manual

For Technical Support/Warranty Information please call 310-762-9944
Smittybilt, 400 W. Artesia, Compton, CA 90220
Installation Instructions
SRC Bumper (Part # SB76612)
2007 Jeep JK SRC Rear Bumper
Revised 12.9.09
Parts Included Qty
93-3913 Rear Bumper 1
90-3925 Nut Plate 2
1/2”-13 X 4 1/2” Gr. 8 Hex Bolt 4
1/2”-13 X 1 1/4” Gr. 8 Hex Bolt 4
1/2” USS Flat Washer 8
1/2” SAE Washer 4
1/2” Hex Nut 4
NOTE: Carefully read entire instructions thoroughly before
attempting to install this part.
STEP 1: Remove the factory rear bumper and hardware from the vehicle.
Step 2: Drill out the (4) holes in the center of the frame to ½”. (Fig A)
(Fig A)
Step 3: Insert nut plate (90-3926) into the inside of the rear frame rails. (Fig B)
Existing rear
frame center holes