Briggs & Stratton 206405GS - Manual (Page 10)

10 BRIGGSandSTRATTON.COM
Features and Controls
Read this Operator’s Manual and safety rules before operating your generator.
Compare the illustrations with your generator, to familiarize yourself with the locations of various controls and
adjustments. Save this manual for future reference.
A - Battery Float Charger — Use battery float charger jack
to keep the starting battery charged and ready for use.
B - Start Switch — Push to start the engine.
C - Fuel Tank — Capacity of seven (7) U.S. gallons.
D - Oil Fill Cap/Dipstick — Check and add engine oil here.
E - Choke Lever — Used when starting a cold engine.
F - Recoil Starter — Used to start the engine.
G - Air Cleaner — Protects engine by filtering dust and
debris out of intake air.
H - Engine Rocker Switch — Set this switch to "On" before
using recoil starter. Set switch to "Off" to switch off
engine.
J - Identification Label — Provides model, revision and
serial number of generator. Please have these readily
available when calling for assistance.
K - Grounding Fastener — Consult your local agency having
jurisdiction for grounding requirements in your area.
L - Circuit Breakers (AC) — The 120 Volt AC, 20A duplex
receptacles are provided with "push to reset" circuit
breakers to protect the generator against electrical
overload.
M - 120 Volt AC, 20 Amp, Duplex Receptacles — May be
used to supply electrical power for the operation of
120 Volt AC, 20 Amp, single phase, 60 Hz electrical,
lighting, appliance, tool and motor loads.
N - Rocker Switch Circuit Breaker — The 120/240 Volt AC,
30A locking receptacle is provided with a rocker switch
circuit breaker to protect the generator against electrical
overload. This switch also controls all receptacles.
P - 120/240 Volt AC, 30 Amp Locking Receptacle — May
be used to supply electrical power for the operation of
120 and/or 240 Volt AC, 30 Amp, single phase, 60 Hz
electrical, lighting, appliance, tool and motor loads.
A
B
C
G
J
D
H
E
F
K
L
M
N
P